Features:1.SPWM technology, pure sine wave AC output powers telecom equipment without performance degradation;2.Continuous duty rated full output wattage maintained even during extended power outages;3.Low EMI and RFI interference characteristics;4.User-friendly Status and Diagnostic LCD/LED display Read More

The following chart lists the currently available, or soon-to-be-released EVs with bidirectional charging capability, including V2G, V2H/V2V and V2L functions. The number listed in the V2L column is the output power rating in kW. VehicleModelConnector TypeV2GV2HV2LAvailableNissan Leaf ZE1ChademoYESY Read More

Currently, there have been significant breakthroughs in the development and utilization of renewable energy worldwide. However, challenges persist in this field, such as the inherent randomness, intermittency, and volatility of solar and wind energy, which impose certain limitations on power sup Read More

A solar charger for scooters operates by harnessing the energy produced by the sun to charge the electric scooter’s battery. This charging process is easy and practical, starting when the solar panels capture sunlight and convert it into electrical energy. The current and voltage are regulated by th Read More

The 48V Electric Forklift has a 3,000 – 4,000 lb. load capacity and the 80V Electric Forklift has load capacities ranging from 4,000 – 17,500 lbs. Read More

Proximity PilotThe proximity pin, PP (also known as plug present), as shown in the SAE J1772 example pinout, describes the switch, S3, as being mechanically linked to the connector latch release actuator. During charging, the EVSE side connects the PP–PE loop via S3 and a 150 Ω R6; when opening the Read More

The signaling protocol has been designed for the following charging sequence.supply equipment signals presence of AC input powervehicle detects plug via proximity circuit (thus the vehicle can prevent driving away while connected) and can detect when latch is pressed in preparation for plug removal. Read More

In 2011, SAE developed a J1772/CCS Combo Coupler variant of the J1772-2009 connector in order to also support the Combined Charging System standard for direct current (DC) fast charging, which includes the standard 5-pin J1772 connector along with an additional two larger pins to support fast DC cha Read More

Charging piles are divided into DC charging piles and AC charging piles.DC charging stationCommonly known as "fast charging", it is fixedly installed outside the electric vehicle and connected to the AC power grid. It uses a three-phase four wire 380V frequency stable frequency of 50HZ, and can also Read More